Fisher-Rosemount RS3 RNI communication protocol

Supported device types and versions
Communication line configuration
Communication station configuration
I/O tag configuration
Literature
Changes and modifications
Document revisions

Supported device types and versions

The protocol implementation supports reading and writing data into the Fisher-Rosemount RS3 system by means of RNI Ethernet network driver (Remote Network Interface) -a TCP/IP network communication is used.

Communication uses the following methods for data acquisition from RNI:

• DDS: Dynamic Data Server – acquisition of process tag values on-change.

• RW Services: Read/Write Services – used for writing values into RS3.

The methods are described in the Fisher-Rosemount Systems RNI Programmer’s Manual documentation, Software Version 2.3, April 1997.

Communication line configuration

• communication line category: API,

• For the other parameters - see the D2000 System configuration.

Communication station configuration

• Communication protocol: Fisher-Rosemount RNI.

• Station address consists of the following parameters :

  • RNI Name – RNI name allows finding RNI IP address (in the Windows NT OS, the name together with the IP address is stored in the file %SystemRoot%\system32\drivers\etc\hosts)

  • Name – user access name (it is configured together with access rights on the boot PC for RNI in the userfile.cfg file – see the RNI configuration manual)

  • Password – password to given access menu

You must pay attention when you select the user's access right (D2000 KOM)  - if writing to RS3 is required, the user access rights must be CONFIGURE.

I/O tag configuration

Possible types: Ai, Ao, Ci, Co, Di, Do, TiA

The address is the name or address of the I/O RS3 tag. For analog I/O tags, the address can be defined in the following forms:

SYSTEM_3_TAG_NAME
SYSTEM_3_ADDRESS
SYSTEM_3_TAG_NAME.COMMAND
SYSTEM_3_ADDRESS.COMMAND

For example:

AI-701 - AI-701 tag output (Q)

=1H-01 - output (Q) of tag =1H-01

AI-701.B - B input of AI-701 tag

=7A-02.@ - all @ flags of tag =7A-02 as a 16-bit unsigned integer

For digital tags, the I/O address can be defined in the following forms:

SYSTEM_3_TAG_NAME.COMMAND\FLAG
SYSTEM_3_ADDRESS.COMMAND\FLAG

Or if COMMAND is @:

SYSTEM_3_TAG_NAME.@FLAG
SYSTEM_3_ADDRESS.@FLAG

For example:

AI-702.U\d

=1H-1.U\c

AI-702.@e

=1H-1.@a

Note:

1. The RS3 tag name is each valid tag name.

2. RS3 address is in =NXXNNN form for I/O blocks and in =NX-NN form for control blocks, where N is a number and X is a character.

3. System flags and 'User' flags that are read as analog values are represented by a 16-bit unsigned integer.

The following table contains valid ‘command’ names for RNIDDE. The first column contains the short name of RS3 I/O tag as the letter T, the tag name is followed by the character (.) and a ‘command‘.